Microprocessor control guarantees high reliability

  Built-in Boost and Buck AVR to stabilize the voltage to our computer against wide utility voltage and brownouts fluctuation

  Pure Sine Wave Output

  Provides Smart RS-232 Communication Port

  "Green Power" Design for energy saving

  Both Free download software from the internet to monitor UPS status

  Provides Overload, Short-Circuit, and Overheat Protection

  SNMP slot allows remote monitoring, start-up, or restart for connected equipment

  4 USB Option.

  4 19" Rack Mount Available

MODEL			SGP-1000	SGP-2000	SGP-3000
CAPACITY	VA/W		1000VA/600W	2000VA/1300W	3000VA/2000W
INPUT	Voltage		120VAC or 220/230/240VAC
	Voltage Range	Acceptable Voltage Range	0-160VAC / 0-300VAC
		Line Low Transfer	88VAC ± 4% or 160/168/175VAC ± 4%
		Line Low Comeback	95VAC ± 4% or 170/178/198VAC ± 4%
		Line High Transfer	148VAC ± 4% or 260/272/275VAC ± 4%
		Line High Comeback	141VAC ± 4% or 248/260/265VAC ± 4%
OUTPUT	Voltage		120VAC or 220/230/240VAC
	Voltage Regulation(Batt. Mode)		±7% RMS for entire battery voltage rangeC
	Frequency		50Hz or 60Hz
	Frequency Regulation (Batt. Mode)		±0.5Hz
	Output Waveform		Pure Sinewave
TRANSFER TIME	Typical		4-6ms
BATTERY	Battery Type		12V/9Ah	12V/9Ah	12V/5Ah
	Battery Number		2 pcs	4 pcs	8 pcs
	Backup Time (at full load)		5 minutes (Typical)
	Recharge Time		4 hours to 95% after complete discharge
INDICATOR	AC Mode		Green LED lighting
	Backup Mode		Green LED flashing
	Boost/Buck		Yellow LED lighting
	Load/Battery Level		It represents Load Level in AC Mode and Battery Level in Backup Mode 4-segment LED bar- 0-25% : 4th LED lighting 26%-50% : 3rd and 4th LEDs lighting 51%-75% : 2nd, 3rd, and 4th LEDs lighting 76%-100% : 4 LEDs in a row all lighting
	UPS Fault		The 2nd LED in a row of Load/Battery LEDs flashing once every second and one or more addition load/battery level LEDs lighting
	Overload		The 1st LED in a row of Load/Battery LEDs flashing once every 0.5 second and all other load/battery level LEDs lighting
	Low Battery		The bottom LED in a row of Load/Battery LEDs flashing every 2 seconds
AUIBLE ALARM	Battery Mode		Sounding every 10 seconds
	Low Battery		Sounding Every 5 Second
	UPS Fault		Continuously Sounding
	Overload		Sounding every 0.5 second
	Battery Replacement		Sounding 2 seconds every 60 seconds
PROTECTION	Full Protection		Under/Over Voltage, Spike and Surge Suppression, Overload, EMI/RFI Filter and Short Circuit Protection
PHYSICAL	Dimension, DXWXH (mm)		365x140x178	465x172x227	502x192x330
	Net Weight (kgs)		14	25	30
ENVIRONMENT	Operating Environment		0- 40°C, 0-90 % relative humidity (non-condensing)
	Noise Level		Less than 45dB
INTERFACE	Smart RS-232		Support Windows 95/98/NT/2000, Novell, and Linux